3D rotating kand cuff tutorial

YOU WILL NEED TO KNOW HOW TO MAKE AN X-BASE CUFF TO MAkE THIS. I HAVE A TUTORIAL HERE: link to x-base cuff

IF YOU HAVE ANY QUESTIONS DON'T HESITATE TO ASK

THESE PICS ARENT MINE BUT I STILL HOPE THEY'RE HELPFUL

you will make your x base cuff, but make it 3 x's high. In the last part of my tutorial where it says, "once your done and satisfied with the height" stop there. Then continue the process of making triangles until it is three x's high, and then continue past that point so it is complete. 

Now, make sure you're stringing through a connector bead. Add two base beads, a connector two and another two base beads, and string through a connector. continue this all around the cuff.

 Now, on the "points" that you just made, string through your two base beads

and now add two base beads and string through the nearest conector bead the way your string is facing

like this. The photo shows only a one x base, but just imagine there are two x's below it.

now string on two more base beads, and string through the connector bead on ur point 

continue going down and up until youve goen all the way around the cuff. now, string down to your lowest connector bead on your x, and repeat the process, making your points, going up and down ect. Then tie it off.

now, make a kandi single using around 40 beads but it between your "buffers"(3d points) and your done!!